deutsch CMOS-Reset - How to reset the CMOS? (Reset BIOS settings)

CMOS-Reset instructions for PC-Mainboards and Notebooks

CMOS-Reset
When should i reset the CMOS?
  • Computer don't boot or freezes during boot process.
  • BIOS-Error messages like "CMOS Checksum Error".
  • Reset lost BIOS-Password (only PC-Mainboards).
  • After making a BIOS-Update (recommendation by many PC-Mainboard manufacturers).
  • After inserting a new BIOS-Chip.

There are of course other situations, but the above are by far the most common reasons to make a CMOS reset.

What is CMOS?
On which computers can i reset a BIOS-Password?
CMOS-Reset with Jumper
CMOS-Reset without Jumper
CMOS-Reset did not solved the problem! What can i do?

 

AT YOUR OWN RISK !

I assume no liability for the accuracy, completeness or topicality of the following instructions. These instructions describe only in general, how to erase the CMOS on PC-Mainboards and Notebooks. It may be completely different for your computer!

 

What is CMOS?

First of all: the CMOS is not the BIOS!
The CMOS (Complementary Metal-Oxide Semiconductor) is a static Random Access Memory (SRAM), which stores the BIOS values. The CMOS will lost its data when removing the voltage/battery (CMOS-Battery, see picture). The duration for a complete loss of data could differs between some seconds, hours, or several days. So it usually won't help to remove the CMOS-Battery for a short time! For this reason, most of all PC-Mainboards have a jumper to immediately reset the CMOS. Notebooks don't have any jumper.

 

On which computers can i reset a BIOS-Password?

YES, on PC-Mainboards you can clear the BIOS-Boot password resp. BIOS-Setup password by resetting the CMOS.

NO, on Notebooks you can not clear the BIOS-Boot password resp. BIOS-Setup password by resetting the CMOS, because most of all (99%) notebooks have a better theft protection. They have an additional small, hidden IC which stores the password. That means: the password is not stored inside the CMOS! But you can also try to reset the CMOS. Other notebooks are able to store the password on a hidden hard disk sector. Your only chance is to contact the support of your notebook manufacturer. Depending on the manufacturer, you have to send him the serial number of the notebook and you'll get (in many cases free of charge) an individual master password to unlock the notebook. Some other manufacturers even offer only the replacement of the notebook's mainboard - which will be really expensive!

 

CMOS-Reset with Jumper
CMOS-Reset

Most mainboard manufacturers have a download section on their websites where you can find the manual of your specific mainboard type. Inside the manual there should be a layout drawing which shows the jumper position.

Read the manual to find out how you can reset the CMOS! Because the procedure can be very different! For instance, most mainboards have to be completely dead, but there are others where you have to reset the CMOS when power is on.

In most cases you can find the jumper (green jumper cap, see picture) nearby the CMOS-Battery. There should be a label like JBAT1, RTCLR, CLRCMOS, CLRCMS, CMOS_CLEAR, Clear RTC, or similar.

There are 4 different CMOS-Jumper types:

3-Pin CMOS-Jumper: The connector strip has 3 pins and the default jumper position is pins 1+2 (see picture). To reset the CMOS move the jumper cap to position pins 2+3.

2-Pin CMOS-Jumper: Depending on the default position, you have to remove or place the jumper.

Soldered points: Sometimes there is no connector strip and you'll only find 2 soldered points which must be bridged (e.g. with a paper clip) to reset the CMOS.

CMOS-Reset-Button: On newer mainboards you'll find different buttons for e.g. Power, Reset and CMOS-Reset. The CMOS-Reset-Button works like a normal CMOS-Reset-Jumper.

Instruction: CMOS-Reset with Jumper
  1. Turn OFF the computer and unplug the power cord (on notebooks remove all accus).
  2. Press the Power On/Off button (PC-Case) 3-5 times to discharge the mainboard condensers.
  3. Remove the coin cell battery (CMOS battery).
  4. Move the CMOS-Jumper to his clear-position (read your mainboard manual to find the jumper).
  5. Wait ~ 15 seconds (the longer the better).
  6. Move the CMOS-Jumper to his default position.
  7. Insert the coin cell battery (CMOS battery).
  8. Plug the power cord (on notebooks insert all accus).
  9. Turn ON the computer, enter the BIOS-Setup and load the "Setup Defaults/Optimized Settings".
  10. Save the BIOS settings and restart the computer.
  11. No success? Repeat the steps 1-10.

Never turn on the mainboard during a CMOS-Reset!
It could cause a short circuit which would damage your mainboard!

 

CMOS-Reset without Jumper
CMOS-Batterie-Sockel CMOS-Batterie-Centmuenze

If your mainboard has no jumper (like most of all notebooks) to reset the CMOS, you can try to remove the CMOS-Battery for a few days and hope that this will clear the CMOS. If you don't like to wait, you can try the following instructions, but as I said at your own risk.

Instruction: CMOS-Reset without Jumper
  1. Turn OFF the computer and unplug the power cord (on notebooks remove all accus).
  2. Press the Power On/Off button (PC-Case) 3-5 times to discharge the mainboard condensers.
  3. Remove the coin cell battery (CMOS battery).
  4. Insert a 10 Euro Cent coin into the CMOS battery socket (or bridge the +/- contacts with a paper clip).
  5. Wait ~ 15 seconds (the longer the better).
  6. Remove the 10 Euro Cent coin (or the paper clip).
  7. Insert the coin cell battery (CMOS battery).
  8. Plug the power cord (on notebooks insert all accus).
  9. Turn ON the computer, enter the BIOS-Setup and load the "Setup Defaults/Optimized Settings".
  10. Save the BIOS settings and restart the computer.
  11. No success? Repeat the steps 1-10.

Never turn on the mainboard during a CMOS-Reset!
It could cause a short circuit which would damage your mainboard!

 

CMOS-Reset did not solved the problem! What can i do?

First you should try the following:

  1. Repeat the CMOS-Reset and increase the time to clear the CMOS from 15 seconds to a few minutes!
  2. Check the voltage of your CMOS-Battery (~3V).
  3. Remove all unnecessary additional hardware like e.g. TV-, Sound-, and Controller cards on your PC-Mainboard (not on Notebooks!). You only need CPU, RAM and Graphic adapter!
  4. If you have more than 1 RAM module, remove the other (maybe one module is defective?).
  5. Reset the Hardware table (DMI):
    the DMI (Desktop Management Interface) manages the integration of various hardware in a computer. Sometimes the DMI data table gets corrupted and you could try to reset it.
    Remove the following hardware components:
    • RAM
    • Graphic adapter (on Desktop-PCs!)
    • all drives like Harddisk, CD, DVD, Floppy, (on Notebooks remove only the Harddisk!)
    • TV-, Sound-, and Controller cards, etc. (on Desktop-PCs!)
    Power on the computer for ~ 30-60 seconds.
    Power off the computer, insert all hardware components and restart the computer.
    Note: if a working BIOS recognizes that some components are missed, the BIOS automatically scans for new hardware and refreshes the DMI hardware table.

 

Nothing works?

  1. Check all cable connections.
  2. Check all components and remove any existing dirt.
  3. Replace CPU, Graphic adapter and the Power Supply Unit. Or use a second PC to check these components.
  4. ElkoCheck all Electrolytic Condensers.

    An electrolytic condenser is a cylindrical electronic component that stores electricity.

    The cylinder is mostly green, blue or black, and has a pressed aluminum cover.
    On older mainboards, it often happened, that the condensers get faulty. In most cases you can identify a defective condenser, when fluid leaked out of the cover, or when the cylinder itself is arched.

 

User-Comments: CMOS-Reset

Einträge: 47

farhanqadeer 19.Feb.2013 18:05

please i have fujitsu siemens pc my pc is every time on i am close pc but my pc is not off please help me i need fujitus siemens bios please send u bios driver

biosflash 7.Dec.2012 18:31

@Nuno Lopes
No. Please contact the Toshiba support.

Nuno Lopes 7.Dec.2012 18:00

I have an Toshiba Sayellite c660-1D0 and i try all and password keeps on. Can you help me? Thanks

Hedi 18.Apr.2012 14:39

Gooooooood work

Thant Zaw Lin 9.Apr.2012 11:24

thank you for all

biosflash 27.Mar.2012 06:36

@cristian
Please read the chapter: On which computers can i reset a BIOS-Password?

cristian 27.Mar.2012 02:31

i have a nec versa c200 that has no cmos how do i reset the bios because the bios is password protected and it has safeboot instaled on the hard drive please help i am desperate

 
COMMENT